![]() This Limited Warranty is conditioned upon proper use of Product by you, the Purchaser. (“ESI”) against manufacturing defects in materials and workmanship for a limited warranty period of One (1) Year for Labor and One (1) year for Parts. This JVC branded “Product”, marketed as new, in the original carton to the original purchaser (“Purchaser”), is warranted by E & S International Enterprises, Inc. A2DP, AVRCPīluetooth Frequency Brand……………. Press and hold to power down unit for Standbyīluetooth Pairing………………………. On BT source, press for next or previous song Press to change source between FM / BT / AUXĪrrow key…………………………………. Power on/off key……………………… Rock Switch On/Off Storage Temperature Range…………… -25 – 70 ☌ Speaker grill finishing……………… Metal “JVC” – Black (0.8mm) ……………………………………………… Battery Status : 100, 75, 50, 25% on LED display when press battery buttonĪuto Standby………………………… Within 15 minutes when BT / AUX has no signal Power / Battery charging Indicator : Red x1 Numerical Buttons (3 programmable FM stations store) Arrows (Previous / Next / Seek FM Frequency) Input Source:……………………… BT / AUX / FM / Micphoneīluetooth Range:………………. Press and hold BT button for 2 seconds to enter into pairing mode. Turn Power switch to Off, and then On again.Make sure the Blue LED on the Speaker is fast flashing (Pairing mode). ![]() Make sure the Bluetooth On/Off switch located below Speaker is slide to On position. ![]() Make sure both Bluetooth device and Speaker is not connected to any other Bluetooth device.Move the Bluetooth device nearer to the Speaker. Make sure the Mic is connected through Mic/Guitar converting the header, and Mic mode is selected (Press Mic/Guitar button) and MidGuitar volume is turned to a reasonable level.Make sure the Guitar is connected through Mic/Guitar converting the header, and Guitar mode is selected (Press Mic/Guitar button) and Mic/Guitar volume is turned to a reasonable level.Make sure the Bluetooth connected device volume is turn to reasonable level.Make sure the Bluetooth connected device output the audio thru BT out.Make sure the Aux connected device volume is turn to reasonable level.Unplug the AC power cord and plug it back again.Turn the Power On/Off switch to Off, and then On again to reset the unit.Plug in the AC power cord to charge and operate. Check the Power On/Off switch is turn to On position.Check that the AC power cord is securely inserted in the unit and the electrical outlet.The main unit will turn on and return to the latest source mode. If the main unit is in Standby mode, press and hold the volume knob for 1 second. Work Mode: When the main unit is in work mode, pressing and holding the volume knob key for 3 seconds will auto enter the unit to Standby Mode.AUX: The main unit will enter standby mode when the main unit is in Aux mode and no Aux cable has been detected for 15 minutes.Bluetooth: When there is no BT Connection, or there is a BT Connection failure, or if the BT has been disconnected for 15 Minutes, the set will go to standby mode and the BT LED Signal will turn off. ![]() The Power Red LED Signal will turn on and other LED Signals will turn off once the main unit is in Standby mode. When connecting each terminal, turn over the waterproof cover and return it after use.
0 Comments
Leave a Reply. |